CAN Expansion

The AiM ACC2 allows you to ACC2 manage up to 4 analog inputs to a max frequency of 200 Hz each. Thermcocouples Thermoresistance 0-5 V 0-12V You can manage a wide range of sensors, from TC to to 12v output. You can also mix them with the 5 optional...

The AiM ACC2 allows you to ACC2 manage up to 4 analog inputs to a max frequency of 200 Hz each. Thermcocouples Thermoresistance 0-5 V 0-12V You can manage a wide range of sensors, from TC to to 12v output. You can also mix them with the 5...

The K8 is a compact keypad based on CAN bus protocols. It comes equipped with eight buttons that have interchangeable inserts. The K8 is water and dust resistant and can be installed inside and outside the cockpit. The red, green, amber, blue, magenta,...

The first item in the new Open AiM Architecture, the GPS09 C Open allows connection to not only AiM devices, but it allows the full 25 Hz data stream to be output on a user configurable CAN message or RS232. Now you can bring this advanced stream to...

The LCU One S is a state of the art Lambda controller with fully configurable CANbus output. With the easy to use AiM Race Studio 3 configuration, adding lambda sensors to your CAN logger or ECU has never been easier.

The LCU One S is a state of the art Lambda controller with fully configurable CANbus output. With the easy to use AiM Race Studio 3 configuration, adding lambda sensors to your CAN logger or ECU has never been easier.

The first item in the new Open AiM Architecture, the GPS09 C Open allows connection to not only AiM devices, but it allows the full 25 Hz data stream to be output on a user configurable CAN message or RS232. Now you can bring this advanced stream to...

Data hubs work like a power strip for the AiM CAN network, allowing you to connect multiple items to your dash/logger. This is the device you need to connect a SCHD, GPS, LCU One, Channel Expansion, and more to your logger. Turns 1 input into 4 and can...

The K8 is a compact keypad based on CAN bus protocols. It comes equipped with eight buttons that have interchangeable inserts. The K8 is water and dust resistant and can be installed inside and outside the cockpit. The red, green, amber, blue, magenta,...

This Binder 712 8 pin male connector is perfect for making your own ACC2 sensor harness or Solo 2 DL ECU connection cable. 

The AiM K6 Keypad adds the easily integration of a keypad to the MXx series of dashes as well as the PDM. Control page functions, add data inputs to be recorded, and control power outputs. Configured and used as a CAN expansion, there is no coding...

This oxygen sensor is a direct replacement for the one included in your kit. It is recommended to replace them when there is a misreading, use with leaded fuels, or damage.