AiM Open

With 10 buttons - 8 CAN and 2 grounding - 3 rotary dials, and a GT centric 320mm diameter, the AiM GT32 wheel is an easy expansion to the PDM32 or PDM08. Simple RaceStudio 3 configuration allows a plug and play system with no advanced knowledge needed...

The AiM ACC2 allows you to ACC2 manage up to 4 analog inputs to a max frequency of 200 Hz each. Thermcocouples Thermoresistance 0-5 V 0-12V You can manage a wide range of sensors, from TC to to 12v output. You can also mix them with the 5...

The K8 is a compact keypad based on CAN bus protocols. It comes equipped with eight buttons that have interchangeable inserts. The K8 is water and dust resistant and can be installed inside and outside the cockpit. The red, green, amber, blue, magenta,...

The K8 is a compact keypad based on CAN bus protocols. It comes equipped with eight buttons that have interchangeable inserts. The K8 is water and dust resistant and can be installed inside and outside the cockpit. The red, green, amber, blue, magenta,...

The first item in the new Open AiM Architecture, the GPS09 C Open allows connection to not only AiM devices, but it allows the full 25 Hz data stream to be output on a user configurable CAN message or RS232. Now you can bring this advanced stream to...

The LCU One S is a state of the art Lambda controller with fully configurable CANbus output. With the easy to use AiM Race Studio 3 configuration, adding lambda sensors to your CAN logger or ECU has never been easier.

The first item in the new Open AiM Architecture, the GPS09 C Open allows connection to not only AiM devices, but it allows the full 25 Hz data stream to be output on a user configurable CAN message or RS232. Now you can bring this advanced stream to...

With the low hysteresis, high accuracy, and high operating temps that stand above the competition, the AiM pressure sensors are offered with flying leads for use with any data system. The flying leads from the sensor are easily integrated into DT, DTM,...

Thanks to the Inductive Contactless Technology, ECLIPSE series assures unmatched wear resistance; no contact means minimum wear and tear therefore no performance degradation during his life cycle.  The continuous research of the best solutions for...

This Binder 712 8 pin male connector is perfect for making your own ACC2 sensor harness or Solo 2 DL ECU connection cable. 

The AiM K6 Open Keypad allows a fully user defined CAN output including bus speed, address, message, and more. Easily integrated with any system that allows a CAN input, you can manage the button states all inside the K6. From momentary, toggle, and...

The AiM flying lead CAN open cables are 7 pin male Binder 712 connectors for connection to the GPS09c Open, K8 Open, ACC2 Open, or LCU One S open. The provide 24 gauge flying leads with +12v, ground, CAN+, and CAN- connections. They can be shortened by...